A Company based on sound economic, technical/scientific and organisational principles and which is in a position to have a say in future developments is a match for the challenges presented by the market and competition.

Suku is an independent company which is characterised by a high level of efficiency and which is always well equipped to meet all eventualities. A company which is always on the lookout for the latest developments in technology on the market. A company which has a say in determining trends and technologies in the field fo pneumatics.

Suku applies special standards to its product range and to advice before and after sales. Suku sales staff are specialists. They sell products which are of benefit and nothing less. They form a team of sales engineers with up-to-date knowledge and they are always ready to deal with customer's problems. They offer specialized, problem-oriented advice. Of course, at Suku, advice is not every thing and sales are not just a secondary matter. But we know what we owe our coustomers. In other words, advice and sales form a single unit for the benefit of the customer.

The application of Suku pneumatic feedres is so wide that people often do not even know that they can use out feeders or not. To make the decision-making easy here are some basic elementary facts which, if taken into consideration. will expidite the automation for your industry.

If you are making any sheet-metal components, you must be using power press on which you have to mount the die of the required component.

• The presses used are of the following types:

• Hand Press
• Mechanical Geared Power Press
• Mechanical Un-Geared Power Press
• Pneumatic Clutch Power Press
• High Speed Presses

• The tools / dies used on either of these presses are of following types :

• Simple Blanking dies
• Progressive or Multi Cavity dies
• Compound plus Progressive dies
Compound dies.

• The raw material used is in the form of coil (basically).
  
  If you are making use of the three things mentioned above and you require an operator to run the machine, then you feel assured that the whole system can be run on automatic mode, using our feeders.

We have installed feeders on all types of presses, all types of dies and possibly all types of raw materials ( metal / non-metal / plastic / paper / foil / cloth etc. ) available in coil form. And there are numerous cases when we installed feeders where the raw material available is in the form of strips.

The incorporation of feeders :

• Eliminates the operator completely

• Gives the accuracies in microns ( hence saving the precious raw material )

• Increases the total productivity in manyfolds

• Eliminates the chances of accidents during the operation ( hence saving the operator from geting injured )

• It increase the life of your power presses and dies, which is far low in case it is run manully ( when operator is running it on manual mode without feeder )

• Precision Accuracy to the tune of 20 microns:
  
• Right to chose Right feeder for every need.