|
 |
Suku Feeder
eliminate all troubles, as they are fitted onto the die set.
Because of their very, competitive price, it is economical to
fit one feeder on each die. In fact you just need to mount the
feeder on the die set and adjust the feeding stroke. You only
need a few minutes for set up, and you will have automatic
units ready for use at all times.
|
HOW TO
SELECT A FEEDER?
-
Max. width
of your strip in coil form
…..mm
-
Max. stroke
length of your feeding
..…mm
-
Max. Min
thickness of your application ..…mm
-
Max.
Strokes per minute of press
......
CONSTRUCTION
FEATURES OF ‘SUKU’ FEEDER:
-
Material Quality
All items which are subjected to sliding motion or shocks,
are extra hardened or hard-chrome plated. The cylinder
liners are in hardened brass.
-
Stroke of Feed Accuracy
Very
strong front and rear shock-absorbers guarantee a very
high stoke or feed accuracy of _0.01 is assured.
-
Thick Sliding Plates
It is possible to realise special guides on the
sliding plates for the feeding of special profiles. On
request, hardened plated or plates in plastic strips or
magnetic strips can be supplied.
-
Sliding Guide Rods
Strong
sliding guides, hardened and ground, are used in our
feeders, The feed pitch adjustment is very easy. It is
enough to shift the rear stop block into the different
groves on the guides
Please
Note:
-We also
design special feeders as per customer’s specification.
-Design and specification are subject to change without
notice as we are continuously Improving our products.
FEED CYCLE
|
1 |
-Press at
TDC (Top dead Center):
-Fixed clamp opened
-Feed clamp closed
|
|
|
2 |
-During press down stroke
-Fixed clamp closes
-Feed clamp open
-Feed clamp fully retracted
|
|
|
3 |
-Press at BDC (Bottom Dead Center):
-Fixed clamp closed
-Feed clamp opens
-Feed clamp fully retracted
|
|
|
4 |
-During press up stroke:
-Fixed clamp opens
-Feed clamp closes
-Strip feeding beings. |
|
|
